Windows users may find it strange to get completely stuck during Microsoft Office installation process. Are you finding a way to force the installation without further issues? Read on.
You’re just 3 steps away from fixing this problem… 1. Download and install the Diagnostic 2. Run full scan 3. Perform system clean-up & repair Estimated download time: 10 Seconds
You’re just 3 steps away from fixing this problem…
1. Download and install the Diagnostic
2. Run full scan
3. Perform system clean-up & repair
Estimated download time: 10 Seconds
Ensure Windows Installer Service is Running
It is possible that the Windows Installer service could not be started during the installation process. You might want to initiate the service and attempt the installation manually.
- Press Windows Key + R.
- Type Services.msc
- Press ENTER.
- It opens up a new dialog with loads of services.
- Right-click the Windows Installer service, choose Properties.
- Select Automatic option in the Startup Type drop-down
- Click Start to execute the service immediately.
- Click Apply, and then OK.
Register Windows Installer
Your Windows Installer components are not registered. It occurs due to a recently failed installation or an abruptly crashed computer. Unregister and reregister the Windows Installer components as outlined below:
- Press Windows Key + X.
- Select Command Prompt (Admin).
- Execute the following commands in given sequence:
- exe /unregister
- exe /regserver
- Reboot your system.
Clean the Disc
Using a good-quality DVD cleaning kit, commercial disc-cleaning solution, or a cotton cloth, gently clean the surface of the installation DVD-ROM. It is highly recommended not to use any plastic or paper material for the purpose of cleaning as it can cause scratches. Wipe from the center to the outward direction.
Run Check Disk
Measure the health of your hard disk, especially the drive selected for installation. The installer may behave strangely due to bad sectors on the hard drive.
- Double click This PC icon on your Desktop.
- Right-click the drive you chose for installation.
- Select Properties.
- Click Tools.
- Click Check.
- Click Scan drive.